Forum Replies Created

Viewing 15 posts - 391 through 405 (of 1,247 total)
  • Author
    Posts
  • in reply to: Cold, cold mid week fly in #14403

    Not bad Kermit, but after adjusting your camera settings, I was expecting it in 4k …………………………….Just sayn.

    in reply to: Sunday Sailing #14388

    Wicky has been struggling a bit lately with his sailing, so I booked him in for one of those TGFS sailing courses last Saturday, but he didn’t turn up?

    in reply to: Boating at the Canal, 17th July #14376

    I didn’t see any video of your barbecue today?……………………………………………………Just Sayn

    in reply to: Ron’s 3D printed Hurricane #14371

    We just need this wind to go away!

    in reply to: Ron’s 3D printed Hurricane #14369

    They do fly!

    in reply to: A fine Winter Sunday of flying #14232

    Only on my boat, Walksnail Avatar system. The difference between the analogue and digital is amazing.

    This is recorded on the Avatar camera,

    in reply to: A fine Winter Sunday of flying #14230

    I agree with Mike, clear video but had a lot of noise in the picture? Could be the bitrate was a bit low when you rendered it?

    Also, you could check the frame rate in your editor timeline, it should be the same as what the camera recorded it at 25 FPS (not fts) Also export it at 25 fps instead of 24.

    This will give a smoother video.

    But other than that, very enjoyable as always, and well done on the Barby……………………………………………..Just sayn

    in reply to: Saturday Boating 1st July 2023 #14224

    Looks the same to me, both in 1080p

    in reply to: Saturday Boating 1st July 2023 #14221

    Have a look at Predator’s fantastic onboard 4K video from today. (Watch it on the big screen)

    in reply to: Saturday Boating 1st July 2023 #14219

    Thanks Ron.

    I think Scotty is a bit more careful with his words now.

    We just need Kermit to step up to 4k.

    in reply to: Sunday Fly-in #14187

    Thanks Bodge.

    Now I am worried!

    in reply to: Saturday Fly-In #14182

    Yeah, we could build another Spitfire when we finish the beer.

    in reply to: Saturday Fly-In #14180

    Yes Chris, that was me.

    All I can say is sorry Ron, but I am looking forward to Scotty handing over the $50.

    in reply to: Sinkers 3D Printed Albatross #14154

    Thanks Mike.

    in reply to: Sinkers 3D Printed Albatross #14151

    Getting closer.

    All servo’s installed, machine guns loaded, just waiting on the prop so I can install the motor and electronics in their correct places.

Viewing 15 posts - 391 through 405 (of 1,247 total)